Elecraft KX3 Programmers Reference Manual de usuario descargar pdf (Pagina 26)

E5, 1-3-2013 [K3, rev 4.51; KX3, rev 1.35]

! [KX3] Added bit to “IC” command to show state of OFS/VFOB LEDs. See byte (e) bit (1).

E6, 2-26-2013 [K3, rev 4.62; KX3, rev 1.38]

! [KX3] Added MACRO menu function to MN table.

E8, 4-15-2013 [K3, rev 4.66; KX3, rev 1.42]

! [KX3] Added LED BRT to MN table (MN145).

E9, 7-30-2013 [K3, rev 4.66; KX3, rev 1.54]

! [KX3] Added PA MODE to MN table (MN146).

E10, 10-7-2013 [K3, rev 4.66; KX3, rev 1.70]

! [K3 and KX3] Clarified the effect meta-mode “K22” on the PC command (power control). In the long

form of the PC set command (PCnnnx;), x controls the parameter of the KPA3 MD or PA MODE menu

entry (K3 and KX3, respectively). This allows the PC command to place the 100-W stage in-line or bypass

it (applies to the K3/100 or KX3+KXPA100).

! [KX3] Added 2M MODE menu entry to MN table (MN147).

E11, 10-24-2013 [K3, rev 4.68; KX3, rev 1.72]

! [K3 and KX3] The SW commands for the “REV” switch on both radios only apply to swapping repeater

input/output frequencies in FM mode (SWT12 in the K3 and SWH24 in the KX3). These SW commands

have no effect in modes other than FM. This is now noted in the SW tables for both transceivers.

1 2 ... 21 22 23 24 25 26

Sin comentarios

Elecraft KX3 Programmers Reference Manual de usuario Pagina 26