Elecraft KX3 Mobile Installation And Operation Guide Manual de usuario descargar pdf (Pagina 12)

Figure 7. West Mountain APP strip feeding the KX3 and other radios. The KX3’s DC power is fed through

the DC‐DC converter shown above the APP strip. The 10 AWG power feed from the trunk‐mounted

relay enclosure is visible on the left. The 10 AWG is fished from the front edge of the rear seat under

the carpet to its exit point about six inches to the left of the APP strip (under the passenger seat). An

upholstery “hook knife” was used to slit the carpet and liner to allow the cable an exit. The ground used

at this location is one of the passenger seat bolts. The input is fused at 10A, which will be changed to

30A when the two empty circuits are populated (future planning).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

Sin comentarios

Elecraft KX3 Mobile Installation And Operation Guide Manual de usuario Pagina 12