ELECRAFT KRX3 Instrucciones de operaciones Pagina 24
- Pagina / 52
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
24
Install the Auxiliary KSYN3 board on the back of the front panel shield between the KREF3 board and the
side panel. Use the hardware exactly as shown in Figure 27. This is most easily done as follows:
Place an inside tooth lock washer over each 1/2” (13 mm) pan head screw, then place the screw in the
hole in the KSYN3 board.
While holding the screws in place, add a split lock washer to each screw on the back side of the board.
Be sure you use split lock washers on the back of the board. Inside tooth lock washers may short
out nearby circuit traces.
Hold the board with the screws and washers in position by lightly pinching the corners of the board with
your thumbs over the screw heads and index fingers holding the split lock washers in place on the back.
Position the board to mate P73 on with J74 on the RF board. Be sure you have the connectors properly
aligned and mate them fully so the screws line up with the PEM nuts on the front panel shield.
Thread each screw into the PEM nut on the front panel shield. Be sure the split lock washer is still in
place between the board and the PEM nut.
Figure 27. Installing the Aux KSYN3 Board.
- ELECRAFT 1
- Contents 2
- Introduction 3
- Customer Service and Support 4
- How ESD Damage Occurs 5
- Preventing ESD Damage 5
- WARNING 5
- Preparing for Installation 6
- Parts Included 7
- KRX3 Hardware Bag E850334 8
- E850344 TMP-BNC Cable Bag 9
- Installation Procedure 11
- CAUTION: 14
- ESD damage. See 15
- CAUTION 23
- Final Assembly 41
- DISPLAY 42
- Operation 43
- Using the Sub Receiver 44
- Diversity Receive 45
- Tools Required 46
- Procedure 46
Altec Lansing 9441A manuali
Manuali dei proprietari e guide per l'utente per Ricevitori e amplificatori Altec Lansing 9441A.
We fornisce 1 manuali pdf Altec Lansing 9441A per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Comentarios a estos manuales