ELECRAFT KRX3 Instrucciones de operaciones descargar pdf (Pagina 37)

Plug the SUBOUT interface board in J64B on the K3 RF board as shown in Figure 47. J64B is between the

K3 roofing filters and the front panel. Be certain the SUBOUT board is aligned so all pins of P1 are engaged

with J64B.

Figure 47. Mounting the SUBOUT Interface Board.

Position the TMP cables so they will be out of the way when you install the KRX3 module. Figure 48

shows a suggested arrangement. The exact cable positions are not important as long as they are below the top of

the SUBOUT board and so they will not interfere with installing the KRX3 module. Avoid kinking the cables.

Arrange them with smooth bends. You may need to unplug one end of the cable and twist the coax slightly so it

will lie in smooth curves where needed.

Figure 48. Positioning the TMP Cables.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Sin comentarios

ELECRAFT KRX3 Instrucciones de operaciones Pagina 37