ELECRAFT KBPF3 Especificaciones descargar pdf (Pagina 11)

Replacing the Top Cover

REPLACE ALL THE SCREWS!

The K3's chassis has excellent rigidity despite its light weight. The screws that hold the top

cover in place are an important part of the structural design. Be sure to replace all the

screws and verify they are tight whenever you replace the cover or other panels

Turn the K3 right side up to replace the top cover. Hold the top cover above the K3, route the speaker wire

under the stiffener bar and plug it into P25 on the KIO3 board at the left rear of the K3 as shown in Figure 6.

TO SPEAKER

ORIENT

CONNECTOR

AS SHOWN

KIO3 BOARD

IN BACK LEFT

CORNER OF

CHASSIS

Figure 6. Connecting Speaker Cable.

Position the top cover on the K3. Note that the tab on the back center goes under the rear lip of the K3 rear

panel. Secure the top cover with the nine 4-40 3/16” (4.8 mm) black flat head screws you removed earlier.

Enable the KBPF3 Module

Enable the KBPF3 using the CONFIG menu as described in the Owner’s Manual. The KBPF3 will not

operate until this is done!

This completes the installation of the KBPF3 module in your K3 transceiver.

1 2 ... 6 7 8 9 10 11

Sin comentarios

ELECRAFT KBPF3 Especificaciones Pagina 11