ELECRAFT K3-Remote El manual del propietario descargar pdf (Pagina 7)

Figure 4

4. Click on the Setup tab to open the window shown in Figure 3.

Figure 3

5. Click on the Get button to open the Setup Info window

(Figure 4), check and correct the following entries as

needed:

I.P. address: This address should match those shown on

pg 5 for the RR-1256 unit you are programming. If

needed, you can enter a new I.P. address (for example, if

you already have another device on your LAN using the

address shown)

Gateway: This must match the I.P. address of the router

that provides your network connection.

DNS Server: This is normally the I.P. address of your

router but some internet service providers assign a

different address.

Web Server Port: This is the port your web browser

uses to communicate with the RR-1256 unit to configure

further settings without your browser. To communicate

with the RR-1256 unit, enter the I.P. address assigned to

it (e.g. for the unit shown in Figure 4, enter

192.168.1.170).

6. Repeat steps 1 through 5 to program the second RR-

1256 unit.

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Sin comentarios

ELECRAFT K3-Remote El manual del propietario Pagina 7