ELECRAFT K3-Remote El manual del propietario descargar pdf (Pagina 9)

9. Check or enter the following data in the Radio Settings window. Note that some are selected using drop-

down menus:

Program Mode 14 Elecraft K3-twin

Sip Password (Optional: No entry required)

Sip Contact (Enter the Public I.P. of your remote router.)

Auto Connect No

Audio Quality 2 – Linear 18 bits 8 kHz

Codec Out Gain 255

Codec Inp Gain 18

Coded Inp preamp 163

Com0 baudrate 9600

Com0 data bits 8

Com0 parity 0 - off

Com0 program mode 3

char timeout

Use USB Com port as

Com0

Note: If you want to customize any of these settings, refer to the RemoteRig

manual at www.remoterig.com

10. When all the above entries are complete, click on the

button and then on the

button when it appears. You will see the message “Settings saved, restarting

device” appear in the window. You can click on the Radio button on the side menu to reinstate the

screen showing all the settings to confirm that the changes were made properly.

11. Disconnect the RR-1256 unit from power and your LAN and connect the RR-1256 remote unit (the one

without the CW knob) to the power supply and LAN.

12. Enter the I.P. address of the RR-1256 unit on the browser’s address bar to open the Microbit program

window. Unless you changed it in step five, the I.P. address is 192.168.1.170.

13. Click on Radio to open the Radio settings window for the Remote RR-1256 unit. Set Audio dual-rx as

follows:

 No: mixes the two audio channels (when separate channels present) so the same audio is heard in

each earphone.

 Yes: provides stereo audio, for example to listen to the sub receiver in the remote K3 in one

earphone and the main receiver in the remote K3 in the other earphone. Note: This setting doubles

the bandwidth required for communications between the local and remote RR-1256. This may

exceed that available in some DSL internet connections.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 18 19

Sin comentarios

ELECRAFT K3-Remote El manual del propietario Pagina 9